[Click images to enlarge]

isa-pwr The ARS Technologies power supply module is designed for the:

  • USB2ISA, USB2ISA-X3
  • XPRS-PCI, XPRS-PCI-X3

    Dimensions: 0.5 X 0.25 X 0.3 inches.

    The power supply module provides additional voltages as follows:
  • -5V/100mA
  • +12V/45mA
  • -12V/45mA
    The power supply module is powered through USB cable, so there is no need of external cables or an external power supply when using the isa-pwr.
    To find the voltages of the peripheral card and do you need the Power Supply Module, please read these articles:
    - for ISA cards .
    - for PCI cards .

    How To Install The POWER SUPPLY MODULE

    The POWER SUPPLY MODULE (ISA-PWR) can be installed on the:
  • USB2ISA
  • USB2ISA-X3
    Installing the POWER SUPPLY MODULE IS SIMPLE.

  • Step 1 Place the POWER SUPPLY MODULE on a flat surface so that the five silver pins of the POWER SUPPLY MODULE are closest to the surface.

  • Step 2 Pick up the isa-pwr and insert the five silver pins into the 6-pin connector that is next to the ISA slot on the USA2ISA, USB2ISA-X3, card.

    NOTE 1: On of the connectors in the 6-pin connector will remain empty because the isa-pwr only has five pins.

    Look at the images below for a visual demonstration of installing the isa-pwr (POWER SUPPLY MODULE)

    Theses instructions are the same for installing the isa-pwr on the USB2ISA, USB2ISA-X3.

    NOTE 2: When applying the isa-pwr, please make sure to have your jumper settings as explained in the User’s Guide.

    The USB2ISA before the ISA-PWR is attached.

    Sample isa-pwr installation


    The isa-pwr is aligned with the 6-pin connector on the USB2ISA .










    Installing the ISA-PWR on the USB2ISA

    install isa-pwr step 1 usb2isa

    Step 1: Position the isa-pwr so that it is aligned with the 6-pin header on the USB2ISA. The 6-pin header is next to the ISA slot on the USB2ISA. Step 2: Place the isa-pwr into the 6-pin connector and gently press down.

    The USB2ISA-X3 before the ISA-PWR is attached.

    Sample isa-pwr installation


    The isa-pwr is aligned with the 6-pin connector on the USB2ISA .


















    Installing the ISA-PWR on the USB2ISA-X3

    install isa-pwr step 1 usb2isa

    Step 1: Position the isa-pwr so that it is aligned with the 6-pin header on the USB2ISA-X3. The 6-pin header is next to the ISA slot on the USB2ISA. Step 2: Place the isa-pwr into the 6-pin connector and gently press down.